電熱培養箱要留意的11個難題

使用電熱培養箱要注意的問題主要有11個，下面讓電熱培養箱廠家帶大家了解一下。

There are 11 main problems to be noticed when using the electric heating incubator. Let the manufacturers of the electric heating incubator take you to know.

1、非必要時，不得打開溫度控制儀以防損壞。

1. When not necessary, do not open the temperature controller to prevent damage.

2、長期不使用時，應切斷電源，嚴禁各處液體進入機內，以免損壞主機。

2. When not in use for a long time, the power supply should be cut off, and the liquid from all places should be strictly prohibited from entering the machine, so as to avoid damaging the main engine.

3、切勿把本機箱體放在含酸、含堿的腐蝕環境中，以免破環電子部件。

3. Do not place the case in the corrosive environment containing acid and alkali, so as not to break the ring electronic components.

4、在通電使用時，切忌用手接觸及箱左側空間的電器部份或用濕布揩抹及用水沖洗。

4. Do not touch the electrical parts on the left side of the box by hand or wipe them with wet cloth or rinse them with water when using electricity.

5、熔絲管裝于箱內左側空間內，調換時需要打開邊門，并必須切斷電源。

5. The fuse pipe is packed in the left space of the box. When changing, the side door should be opened and the power supply must be cut off.

6、電源線不可纏繞在金屬物上，不可放置在高溫或潮濕的地方，防止橡膠老化以致漏電。

6. The power cord should not be wound on metal objects. It should not be placed in high temperature or humid places to prevent rubber from aging and leakage.

7、每次使用完畢后，須將電源切斷。經常保持箱內外清潔和水箱內水的清潔。

7. After each use, the power supply must be cut off. Always keep the inside and outside of the tank clean and the water inside the tank clean.

8、當使用溫度較高時，應注意小心燙傷。

8. When using at a higher temperature, care should be taken for scalds.

9、注意保護電熱恒溫培養箱箱體漆面影響箱體外形美觀。

9. Attention should be paid to the protection of the paint surface of the incubator, which affects the appearance of the incubator.

10、本箱為不防爆型，故腐蝕性及易燃性物品禁止放入箱內。

10. This box is non-explosion-proof, so corrosive and flammable articles are prohibited to be put into the box.

11、試驗物放置在箱內不宜過擠，使空氣流動暢通，保持箱內受熱均勻，內室底板靠近電熱器，故不宜放置試驗物。在實驗室，應將風頂活門適當旋開，以利調節箱內溫度。

11. The test material should not be placed in the box to make the air flow smoothly, keep the heat uniform in the box, and the bottom of the inner chamber is close to the electric heater, so it is not suitable to place the test material. In the laboratory, the top valve should be properly switched to facilitate the adjustment of temperature in the box.

http://www.yysjd315gw.com